Siding in Madison has one job that siding in a mild climate does not: surviving roughly 60 freeze-thaw cycles a year without cracking, cupping or pulling away from the sheathing. What goes behind the panels matters as much as the panels themselves, and that is where most Madison siding jobs go wrong.
The failure mode changes with the material and the build era. Here is what we find on Madison homes.
Isthmus and near east
Original wood clapboard or cedar shake, often under one or two layers of later material. Removing it is where the real work is — we usually find failed sheathing, no house wrap, and knob-and-tube penetrations that need attention before anything goes back on.
Ranches and split-levels
Original aluminum, steel or hardboard, much of it chalking, dented or delaminating at the bottom courses. Hardboard from this era absorbs water at the butt joints and fails from the inside out, which is why it looks fine until it doesn’t.
Established subdivisions
First-generation vinyl reaching end of life. Wisconsin’s temperature swing makes vinyl expand and contract more than the fastening allowed for, so you get wavy runs, popped courses and cracked corners on south and west elevations.
Newer builds
Builder-grade vinyl with minimal insulation behind it. These are the homes where a siding replacement is really an energy project — the wall assembly matters more than the color.
Full re-sides, partial replacement, and the repair work that’s usually hiding behind the old siding.
The most durable option for this climate. Will not crack in freeze-thaw, holds color, and carries a long factory finish warranty.
Real wood texture with far better impact resistance than vinyl. A good middle option on Madison’s older homes.
Lower cost with an insulation backer that adds R-value and stiffens the panel so it stays flat.
Highest hail resistance of anything we install. Worth considering on exposed west-facing elevations.
Where siding jobs succeed or fail. We inspect and replace failed sheathing rather than covering it.
Almost always replaced with the siding. Rotted fascia is the most common thing we find behind old gutters.
Two-story homes, complex trim, and sheathing replacement move the number. Hail damage to one elevation is often a covered insurance claim rather than an out-of-pocket project.
Loved Working With Us?
Leave Us A Google Review!
Share Your Experience!
Help Us Help Others!
Fiber cement and engineered wood both handle freeze-thaw better than vinyl, because they move less with temperature. Steel is the most impact-resistant if hail is your main concern. The honest answer depends on your budget and how long you plan to stay, and we will walk through the trade-offs at the estimate rather than pushing one product.
Vinyl becomes brittle in deep cold and we avoid installing it below roughly 40 degrees. Fiber cement and steel are less affected. We schedule around it rather than forcing a job that will look wrong in spring.
On homes built before 1980, often yes, especially at the bottom courses and around windows. We price sheathing replacement as a known line item at the estimate rather than surprising you with a change order once the wall is open.
Frequently, and homeowners miss it because they only look at the roof. Hail cracks vinyl and dents aluminum and steel. If your roof was approved for a claim, the siding on the same elevation is worth inspecting before the claim closes.
Insulated siding and a properly detailed house wrap help, but siding is not a substitute for attic insulation, which is where most Madison homes lose heat. We will be straight with you about what to expect rather than selling it as an energy retrofit.
Get your free, no-obligation inspection today.